Switch-on delay#
Block appearance in REPEAT VISION#
The Switch-on delay block delays the signal by a specified amount after the start of the simulation. This block can output either 0 (if the signal is less than or equal to 0) or 1 (if the signal is greater than 0).
1. Properties#
Property |
Default value |
Description |
Units of measurement |
|---|---|---|---|
Delay time |
1.0 |
- |
s |
Sampling type: |
Fundamental project frequency decimation |
- |
- |
Decimation factor of project fundamental discretization frequency, available when selecting |
1 |
- |
- |
Sample time, available when selecting |
0.05 |
- |
s |
Sampling frequency, available when selecting |
20.0 |
- |
Hz |
2. Inputs and outputs#
Parameters |
Input/Output |
Description |
Units of measurement |
Port type |
|---|---|---|---|---|
Input |
Input |
Signal |
- |
Automation |
Output |
Output |
Signal |
- |
Automation |
In order to see the connection capabilities of the block, you need to go to page Description of block ports
3. Code generation#
Important
Block supports C source code generation
See also
An example of using this block can be found in subsection Power industry of section Electrical equipment practical guide Modeling of zero-sequence current directional protection of 220 kV power transmission lines.