Three-phase two-level converter#

The block implements a model of three-phase converter built according to a bridge diagram. The switching device of the converter is a special component, IGBT transistor, connected in parallel with the reverse diode. The bias voltage of the transistor and diode are not considered. RC damper circuit can be connected in parallel to each pair of these components.

Switching devices of the converter are controlled by an input vector signal of the form [S1, S2, S3, S4, S5, S6] coming to the Control input. Indices of vector signal components correspond to numbering of switching devices in the diagram (see Fig. 1 below). Control can be carried out using Two level PWM generator when 3 arm is selected in Bridge converter type property, as well as using individual pulses generated by the Automation section blocks and collected into one vector signal with dimension equal to 6 using the Multiplexer block.

Fig. 1 Single-phase bridge converter diagram#

1. Properties#

Property	Default valu	Description	Units of measurement
On-state resistance	0.001	-	Ohm
Off-state resistance	1.0e8	-	Ohm
Snubber circuit	On	-	-
Snubber resistance	1000000.0	Available, when `Snubber circuit` - `On`	Ohm
Snubber capacitance	1000000.0	Available, when `Snubber circuit` - `On`	F

2. Inputs and outputs#

Parameters	Input/Output	Description	Units of measurement	Port type
Control input	Input	-	-	Automation
+	Input	-	-	Electronics
-	Output	-	-	Electronics
А	Output	-	-	Electronics
В	Output	-	-	Electronics
С	Output	-	-	Electronics

In order to see the connection capabilities of the block, you need to go to page Description of block ports