Pressure and temperature meter (MF)#

The Pressure and temperature meter (MF) block allows you to measure pressure and temperature values in the nodes of a multi-component hydraulic network.

The sensor has 1 port for connection to a pressure or temperature control point and measures the value of the parameter in this node.

\[P=P_{вх}\]

where \(P_{in}\) is the excess or absolute (depending on the selected parameter in the Type of pressure property) pressure in the node connected to the input port of the block, [Pa].

\[T=T_{вх}\]

where \(T_{in}\) is the temperature in the node connected to the input port of the block, [℃].

Note

One sensor can operate in several modes:

Measure only pressure, only temperature;
Measure both pressure and temperature simultaneously.

Hint

After adding the sensor to the circuit, use the appropriate switches to configure it, including the parameters to be measured.

1. Properties#

Property	Default Value	Description	Units of measurement
Type of pressure: Absolut; Gauge	Absolut	Available, when `Pressure` - `On`	-
Pressure	On	-	-
Temperature	On	-	-

2. Inputs and outputs#

Parameters	Input/Output	Description	Units of measurement	Port type
Input	Input	-	-	Multicomponent fluid
Pressure	Output	Available, when `Pressure` - `On`	Pa	Automation
Temperature	Output	Available, when `Temperature` - `On`	-	Automation

In order to see the connection capabilities of the block, you need to go to page Description of block ports