Check Static Gap#

The Check Static Gap block checks that the input signal is less than (or possibly equal to) the static lower boundary or greater than (or possibly equal to) the static upper boundary at the current time step. The Upper bound and Lower bound parameters define the upper and lower gap boundaries. The block then performs an assertion after the comparison. If the signal goes beyond the gap, the statement is true (1) and the block performs nothing. If not, the block stops the simulation and returns a default error message.

1. Properties#

Property	Default Value	Description	Units of measurement
Enabled check	On	Block accounting when calculating	-
Availibility of calculation stop	On	Stops calculation in case of check error	-
Availibility of output port	Off	Responsible for output port visibility	-
Upper bound	1	Upper gap boundary	-
Lower bound	0	Lower gap boundary	-
Include upper bound in gap	On	Boundary accounting when comparing	-
Include lower bound in gap	On	Boundary accounting when comparing	-
Message when assertion fails	error	Check error response message	-

2. Inputs and outputs#

Parameters	Input/Output	Description	Units of measurement	Port type
Input	Input	-	-	Automation
Output	Output	Available when property `Availability of output port` - `On`	-	Automation

In order to see the connection capabilities of the block, you need to go to page Description of block ports

3. Code generation#

Important

Block supports C source code generation