Full-bridge rectifier#
Block appearance in REPEAT VISION#
The block implements a model of a single-phase rectifier made according to the bridge diagram and consisting of 4 diodes (see Fig. 1 below). The block allows selection of linear or exponential model of diodes. For a linear diode model, it is possible to connect a parallel RC damper circuit.
Fig. 1 Single-phase bridge rectifier diagram#
1. Properties#
Property |
Default value |
Description |
Units of measurement |
|---|---|---|---|
Diode model: |
Exponential |
– |
– |
Saturation current, available when selecting |
1.e-12 |
– |
А |
Diode temperature, available when selecting |
293 |
The diodes temperature for which their other parameters are indicated |
K |
Emission coefficient, available when selecting |
1 |
– |
– |
Diode resistance, available when selecting |
0.01 |
– |
Ohm |
Forward voltage, available when selecting |
0.5 |
– |
V |
Reverse voltage, available when selecting |
1.0E10 |
– |
Ohm |
Snubber circuit, available when selecting |
On |
– |
– |
Snubber capacitance, available when selecting |
1.0E-6 |
– |
F |
Snubber resistance, available when selecting |
1000000.0 |
– |
Ohm |
2. Inputs and outputs#
Parameters |
Input/Output |
Description |
Units of measurement |
Port type |
|---|---|---|---|---|
1 |
Input |
- |
- |
Electronics |
2 |
Input |
- |
- |
Electronics |
- |
Input |
- |
- |
Electronics |
+ |
Output |
- |
- |
Electronics |
In order to see the connection capabilities of the block, you need to go to page Description of block ports