LED RPA#
Block appearance in REPEAT VISION#
The LED RPA block implements signaling logic. The block’s internal logic allows for signal recording when protection is triggered using a trigger (signal recording/set). It’s possible to add a blinking condition (blinking control/act). Control cabinet power has been added to the alarm logic (control cabinet power accounting/power) and lamp monitoring (lamptest). Alarm reset is performed via the alarm reset/reset input.
When the lamp control is active, only the LEDs light up. If the power is lost, the lamp control does not function.
1. Properties#
No
2. Inputs and outputs#
Parameters |
Input/Output |
Description |
Units of measurement |
Port type |
|---|---|---|---|---|
Alarm reset |
Input |
– |
– |
Automation |
Lamp test |
Input |
– |
– |
Automation |
Power supply from control cabinet |
Input |
– |
– |
Automation |
Flashing control |
Input |
– |
– |
Automation |
Set a signal when the protection is triggered |
Input |
– |
– |
Automation |
Signal output to terminal |
Output |
– |
– |
Automation |
Output alarm 1 |
Output |
– |
– |
Automation |
Output alarm 2 |
Output |
– |
– |
Automation |
In order to see the connection capabilities of the block, you need to go to page Description of block ports