Check Dynamic Gap#

The Check Dynamic Gap block checks that the signal goes beyond the range of values at each time step and performs an assertion after the comparison. The width of the gap may vary from time step to time step. The input port is the input signal being tested. Inputs Lower bound and Upper bound define the lower and upper gap boundaries, respectively. If the signal falls outside the gap defined by the boundaries, the statement is true (1) and the block performs nothing. If not, the block stops the simulation and returns a default error message.

1. Properties#

Property	Default Value	Description	Units of measurement
Enabled check	On	Block accounting when calculating	-
Availability of calculation stop	On	Stops calculation in case of check error	-
Availability of output port	Off	Responsible for output port visibility	-
Check error message	error	Check error response message	-

2. Inputs and outputs#

Parameters	Input/Output	Description	Units of measurement	Port type
Upper bound	Input	Upper gap boundary	-	Automation
Input	Input	-	-	Automation
Lower bound	Input	Lower gap boundary	-	Automation
Output	Output	Available when property `Availability of output port` - `On`	-	Automation

In order to see the connection capabilities of the block, you need to go to page Description of block ports

3. Code generation#

Important

Block supports C source code generation