Check Input Resolution#

The Check Input Resolution block checks whether the input signal has the specified resolution. If the resolution parameter is a scalar, the block calculates the input signal modulus from the provided scalar resolution. The computed modulus is then compared to tolerance 10e-3 and an assertion is made after the comparison. If the modulus is less than the tolerance, the statement is true (1) and the block performs nothing. If not, the block stops the simulation and returns a default error message.

1. Properties#

Property	Default Value	Description	Units of measurement
Enabled check	On	Block accounting when calculating	-
Availibility of calculation stop	On	Stops calculation in case of check error	-
Availibility of output port	Off	Responsible for output port visibility	-
Message when assertion fails	error	Check error response message	-
Resolution	1	-	-

2. Inputs and outputs#

Parameters	Input/Output	Description	Units of measurement	Port type
Input	Input	-	-	Automation
Output	Output	Available when property `Availability of output port` - `On`	-	Automation

In order to see the connection capabilities of the block, you need to go to page Description of block ports

3. Code generation#

Important

Block supports C source code generation