Check Dynamic Upper Bound#

The Check Dynamic Upper Bound block checks whether the In reference signal is greater than the Bound input signal amplitude at each time step and performs the statement after the comparison. If Bound is greater than the input signal, the statement is true (1) and the block performs nothing. If not, the block stops the simulation and returns a default error message.

1. Properties#

Property	Default Value	Description	Units of measurement
Enabled check	On	Block accounting when calculating	-
Availibility of calculation stop	On	Stops calculation in case of check error	-
Availability of output port	Off	Responsible for output port visibility	-
Message when assertion fails	error	Check error response message	-

2. Inputs and outputs#

Parameters	Input/Output	Description	Units of measurement	Port type
In	Input	-	-	Automation
Bound	Input	Upper bound	-	Automation
Output	Output	Available when property `Availability of output port` - `On`	-	Automation

In order to see the connection capabilities of the block, you need to go to page Description of block ports

3. Code generation#

Important

Block supports C source code generation